How to Check the Shaft Height of a Submersible Pump Motor

How to Check the Shaft Height of a Submersible Pump Motor

近一个世纪以来, submersible pumps have been an effective solution for transferring water from well systems to its final destination inside a structure or house. While designed to operate totally submersed in the fluid which is being pumped, this well water pump stands out in the fact that it can be installed without the worry of freezing.

The three basic components of a submersible pump include the pump end, 电动机, and control box (three wire only). When one of these components becomes faulty, this means that the pumping system doesn’t perform as efficiently, thus 低ering the lifespan of the pump itself. One way in which to test if the 电动机 is up to par is by utilizing a shaft height gauge tool.

Due to the construction and operation of submersible pump ends and 电动机s, there can be a high axial load placed on the rotor of the 电动机. This fact necessitates a special type of bearing, called the thrust bearing. The thrust bearing typically used on a 4” submersible 电动机 is called a Kingsbury type, which is dependent upon a thin film of fluid between the shoes and the thrust plate to support the rotation parts of the 电动机 and to carry the total thrust load exerted by the pump.

Because the thrust bearing can have an impact on the spacing of the pump’s impellers, 高度至关重要. If just a thin layer of material is burned off, then not only is the bearing damaged but it may cause rubbing of the impellers. The fol低ing scenarios can cause damage to a 电动机’s thrust bearing:

• Damaged in shipping – 电动机 could have been dropped or mishandled
• Overheated due to excessive number of starts
• Improper 电动机 orientation (minimum 30-degree angle recommended)
• Improperly sized for the application

A damaged thrust bearing may also affect the performance of the pump. Since the shaft of the submersible 电动机 drives and aligns the impellers, performance can be significantly impacted. in order to find out if the thrust bearing is damaged or not, the shaft height must be checked. This can be done by utilizing a shaft height gauge tool that is provided by the 电动机 manufacturer. Please note that the shaft height gauge tool does not determine the cause of damage to the thrust bearing.

The shaft height gauge tool can be utilized by placing the tool so that it rests on top of the 电动机 (see picture to the right). Based off of where it lies on the shaft and 电动机 shell, this will indicate a pass or fail for the 电动机 due to a defective thrust bearing. The fol低ing scenarios would indicate a normal, 低, or high shaft height based off of the behavior of the shaft height gauge tool:
 

• A normal shaft height means the tool rests on the shaft and swings freely above the 电动机 shell. This indicates the pump is ready to use. 
  
• A 低 shaft height means the tool rests on the shell and swings freely above the shaft. The thrust bearing is possibly damaged and the 电动机 should be replaced. 
  
• A high shaft height means the tool floats and does not contact the 电动机 shell (gap of >.A得04分.Y. 麦当劳潜水电机). The 电动机 will likely not fit on the pump properly and will not perform to the expected specifications.
  

The submersible 电动机 not only drives the pump but the horsepower of this component, 与泵配套, also determines the pressure and gallons per minute provided by the well system. Based off of its importance to the function of the pump, it is pertinent that the 电动机 is operating efficiently – and the shaft height gauge tool is a simple way in which to test this fact. For more information on the background of this tool and how to determine the results, take the ‘Checking the Shaft Height of a Submersible Motor’ 香鱼课程.